Step by step - hand carving a sunflower stamp

I was so happy to get a new commission to create a large sunflower stamp for my customer's wedding invitations. How exciting! Not only carving the largest stamp I think I've ever carved but mostly knowing that something I created will be incorporated into someone's very special day. I began with a sketch approved by the customer. It's roughly 3.5" x 3.5" square (or in this case, circle).
I like to sketch in ink, so I've gone over the design with pencil to be burnished onto the rubber as seen above. Basically just trace your design in pencil on paper, flip it onto the rubber, then rub the paper with something smooth like a burnishing board or a smooth handle on a butter knife.


Next, I've carved out around the petals with an Exact-o knife.


Here comes the fun part, carving out the design with my Speedball carving tool.



Now to test the stamp - looks great!



Now I'm ready to glue the stamp to the back of a prepped wood mount. I have painted it this happy yellow in an acrylic paint and then spray varnished it. I use E-6000 glue for a really solid seal.





For the top of the wood mount, I've added a stamped piece of sticker paper and spray varnished it again (it will get a couple more coats when it's done). All that's left to do is lacquer the exposed wood in the back and it will be good to go!

This will be going out to a very kind customer that's been a pleasure to work with but I think this may be the start of something as far as a prototype for over sized stamps. What other designs would you like to see in this large scale?